Y-Type Strainer | SS316 Body | ANSI 150 Flanges | Water, Steam, Gases and Process Fluids
Pickup availability could not be loaded
SS316 ANSI 150 Y-Strainer — Line Protection for Water, Steam, Gases, and Process Fluids
Cematic's SS316 ANSI 150 Y-strainer protects pumps, control valves, flow meters, and other instrumentation equipment from solid particles, pipe rust, and scale circulating in the process line.
Its Y-design allows the filter element (mesh) to be installed in a compact, low-profile body, with direct access for cleaning or replacement without the need to remove the adjacent piping.
The SS316 stainless steel body offers corrosion resistance in fluids with chlorides, process water, and moderately aggressive environments where a cast iron or carbon steel body would not be sufficient.
Therefore, it is the correct specification for chemical, pharmaceutical, food, and water plants where the filter's contact with the fluid must meet hygiene or chemical resistance requirements.
SS316 Y-Strainer Mesh — Selection by Fluid
The filter mesh for this SS316 ANSI 150 Y-strainer is specified according to the particle size that needs to be retained and the equipment that needs to be protected downstream:
- 20-40 Mesh (Coarse): general protection for centrifugal pumps and control valves against coarse sediment, sand, and installation debris in water and process lines.
- 60-80 Mesh (Medium): recommended upstream of flow meters, pneumatic positioners, and precision control valves, where fine particles would affect calibration or seating.
- 100+ Mesh (Fine): protection for sensitive instrumentation and chemical dosing systems where very fine particles need to be retained.
Technical Specifications of the SS316 ANSI 150 Y-Strainer
| Parameter | Value |
|---|---|
| Type | Y-strainer, line strainer |
| Body Material | SS316 stainless steel |
| Mesh Material | SS304/SS316 stainless steel |
| Connection | ANSI 150 RF flanges — ASME B16.5 drilling |
| Nominal Diameters | 1" to 4" (DN25 to DN100) |
| Nominal Pressure | ANSI 150 — up to 19.6 bar at room temperature, reduced at higher temperatures according to ASME B16.34 |
| Operating Temperature | -20 °C to +200 °C depending on flange gasket |
| Purge/Drain Plug | Included, for cleaning without removing the mesh |
| Design Standard | ASME B16.34 / ASME B16.5 |
SS316 Y-Strainer Fluid Compatibility
- ✅ Potable water, process water, and cooling water
- ✅ Saturated steam and condensate
- ✅ Compressed air and dry industrial gases
- ✅ Chemical process fluids with moderate chlorides, where SS316 offers better resistance than an iron or carbon steel body
- ✅ Food and pharmaceutical fluids requiring a stainless steel body
- ⚠️ Fluids with high concentrations of abrasive solids: check mesh cleaning frequency with the technical team
- ❌ Concentrated acids or aggressive solvents outside the chemical resistance of SS316: consult special alloys
Applications of the SS316 ANSI 150 Y-Strainer
- Centrifugal Pump Protection: this SS316 ANSI 150 Y-strainer is installed upstream of the pump suction to prevent damage to the impeller from solid particles in the line.
- Control Valve Protection: installed before globe control valves or other types, it prevents premature wear of the seat and disc caused by suspended particles.
- Measurement Instrumentation Protection: upstream of flow meters and positioners, it prevents particles from affecting reading accuracy or calibration.
- Steam and Condensate Lines: retains scale and pipe rust before steam traps and pressure-reducing valves.
For the complete category of valves and line accessories, see Cematic Control Valves
